Automotive partsIllustrative content — structure only

Dimensional stability for precision injection parts

Warpage traced through the dimension chain, measurement and flow review, then process and gauge adjustments restored batch stability.

Coordinate measuring machine probe inspecting a part

Background

The customer's injection-moulded housing showed intermittent interference at the assembly station. Sampled dimensions fluctuated near the tolerance limit, rework rose, and the cause was unclear.

Flow analysis results did not match measured deviation. The customer wanted the source of the deviation clarified before deciding whether to change the mould.

Results

  1. 01

    Warpage occurred mainly along the long edge, related to insufficient cooling time and uneven holding pressure.

  2. 02

    After adjustment, critical dimensions of three consecutive batches stayed in the middle of the tolerance band.

  3. 03

    Gauges and acceptance rules were recalibrated, and the assembly station no longer depended on manual fitting.

Our work

01

Dimension chain mapping

Broke the dimension chain down by assembly relationship to identify which dimensions actually drive interference, instead of working on all dimensions equally.

02

Measurement and flow review

Sampled critical surfaces and hole positions with a CMM and compared them with flow results to locate where and in which direction warpage occurred.

03

Process parameter adjustment

Adjusted holding pressure curves and cooling time in stages, observed warpage change, and identified the most dimension-sensitive process items.

04

Gauges and acceptance rules

Reset gauge positioning and acceptance baselines to the adjusted process so line inspection matched the physical part.

Process and samples

Other records in this direction

Back to list

Have a similar requirement?

Describe the material, process or compliance question. We judge feasibility first, then discuss project scope.