01

New material development consulting

From material screening to pilot verification — a formulation built for production.

For engineering plastics, composites, metals and surface treatment, we handle material selection, formulation design, performance verification and small-batch trials, so cost, performance and process window are decided on data.

Twin-screw extruder screw elements in close-up
01

What we take on

01

Material system selection and substitution

Map material requirements to actual service conditions, compare current and alternative routes, and deliver an executable selection conclusion.

02

Formulation design and modification direction

Set modification goals around strength, toughness, weathering and processability, and define the additive system and ratio range.

03

Mechanical, thermal and aging verification

Organise specimen preparation and key property tests, then judge with data whether the route reaches the target range.

04

Small-batch trial and process window

Confirm the injection, extrusion or compounding window on existing equipment and issue trial parameters.

02

Typical scenarios

Problems we have broken down into measurable work.

Engineering plastic substitution and cost reduction

Assess domestic alternatives to imported grades without changing assembly interfaces or structural strength, then complete specimen comparison and trial verification.

Injection specimen and test-part comparison

Compare candidate routes on the same specimen geometry, so differences can be attributed to material rather than test setup.

Surface treatment and weathering verification

For outdoor and humid conditions, evaluate coating and plating routes on corrosion and weathering performance and narrow them to a usable process.

03

Deliverables and stages

Stage

01Assessment

Deliverable

Material status and target property comparison

Acceptance

Indicators, priorities and thresholds defined

Stage

02Route proposal

Deliverable

Material route and formulation recommendation

Acceptance

Route confirmed by small-sample comparison

Stage

03Verification

Deliverable

Specimen test report and data review record

Acceptance

Key indicators inside the target range

Stage

04Launch support

Deliverable

Trial process parameters and incoming material standard

Acceptance

First trial batch reproducible

Related records

All cases

Not sure which direction to start from?

Describe the problem. We give a judgement first, then discuss the project.